Acme Trendz Australia

Discover the seamless installation process that brings our natural stone creations to life on your spaces.

  • Installation Process of Exterior Applications

  • Step 1

    « Measure the surface you plan to cover. The surface to be treated should be thoroughly clean and dry. Mix the Adhesive Part A with the Adhesive »

  • Step 2

    « Part B in a ratio of 1 to 1 until a homogeneous mixture is obtained Apply the Adhesive mixture to the desired surface »

  • Step 3

    « Spread the Adhesive mixture with a notched trowel. Place the Sheet on the chosen surface Roll over the entire surface, making sure to apply pressure throughout the area. »

  • Step 4

    « Wait 24 hours until the adhesive dries completely. Sand the corners with sand paper. Protect the corners of the sheet with masking tape. »

  • Step 5

    « Apply the grout to the joints Remove the tape and apply the Sealant on the entire surface Let the Sealant dry for 24 hours. »

  • Download PDF

    «  Download installation pdf  »

Installation Process of Interior Applications
Step 1
Measure the surface you plan to cover. The surface to be treated should be thoroughly clean and dry. Using a caulking gun, apply the adhesive
Step 2
Apply adhesive around the perimeter leaving an offset of ¾” width leaving spaces of approximately 1¼” between each adhesive strip
Step 3
Spread the Adhesive mixture with a notched trowel. Place the Sheet on the chosen surface Roll over the entire surface, making sure to apply pressure throughout the area
Step 4
Wait 24 hours until the adhesive dries completely. Sand the corners with sand paper. Protect the corners of the sheet with masking tape
Step 5
Apply the grout to the joints Remove the tape and apply the Sealant on the entire surface Let the Sealant dry for 24 hours

Going further

Reach out to us and let's start shaping your vision together?